How To Light Pilot Light On Old Gas Fireplace 2021

0 Comments

How To Light Pilot Light On Old Gas Fireplace 2021. The pilot light in a gas fireplace is typically found adjacent to the main burner, below the fireplace media such as logs or coals. Otherwise, hold a long match or lighter close to the pilot tube orifice.

Gas Fireplace Pilot Light With Tv UPC 761644603001 from manunfc.blogspot.com

If the light goes out, you may need to assess your pilot light. The pilot light in a gas fireplace is typically found adjacent to the main burner, below the fireplace media such as logs or coals. Light a match and hold it directly beneath the tube in the pilot opening.

I Haven't Put It On On (You Only Put It To On After The Pilot Lights).

The flame should remain lit after releasing the button. As the pilot light is required to help start the main burner flames. This will stop the flow of gas into the room.

Otherwise, Hold A Long Match Or Lighter Close To The Pilot Tube Orifice.

Turn the knob to pilot. You can either use the sparked or a match to start the pilot light. Turn the control knob to the “pilot” position to turn on the gas fireplace.

It Takes A Few Seconds To Get Enough Gas In The Pipe To Start The Pilot Light.

Turn the knob on your furnace to “off.”. Open valve by pivoting handle to be. Once the pilot lights, keep holding down the gas control knob for 20 to 30 seconds to allow time for heating up the thermocouple (a safety device), then release the knob so it pops back up.

Press And Hold The Pilot Control Knob Down Until The Flame Lights.

You must now wait a minute for the flame to die out. By following along, you will be able to avoid a future filled with daily relighting, and you will also learn all of the safety tips you need to avoid unfortunate gas accidents. When the pilot light is on stop press on the ignition switch.

It Is Done By Moving The Knob Until It Is In The Position Of Pilot.

The gas will be able to flow into the pilot light due to this. Place the wall key into the gas valve and turn it toward the “on” position. Remove the match, but continue to hold the knob down.

Tags:

Leave a Reply

Your email address will not be published. Required fields are marked *